QMemoryBarrier Class
class Qt3DRender::QMemoryBarrierClass to emplace a memory barrier. More...
| Header: | #include <QMemoryBarrier> |
| qmake: | QT += 3drender |
| Since: | Qt 5.9 |
| Instantiated By: | MemoryBarrier |
| Inherits: | Qt3DRender::QFrameGraphNode |
This class was introduced in Qt 5.9.
Public Types
| enum | Operation { None, ElementArray, Uniform, TextureFetch, ShaderImageAccess, …, All } |
| flags | Operations |
Detailed Description
A Qt3DRender::QMemoryBarrier FrameGraph node is used to emplace a specific memory barrier at a specific time of the rendering. This is required to properly synchronize drawing and compute commands on the GPU.
The barrier defines the ordering of memory operations issued by a prior command. This means that if command1 is manipulating a buffer that is to be used as a vertex attribute buffer in a following command2, then the memory barrier should be placed after command1 and setting the appropriate barrier type for vertex attribute buffer.
When a QMemoryBarrier node is found in a FrameGraph branch, the barrier will be enforced prior to any draw or compute command even if these are defined deeper in the branch.
For OpenGL rendering, this page gives more info about the Memory Model
Member Type Documentation
enum QMemoryBarrier::Operation
flags QMemoryBarrier::Operations
This enum type describes types of buffer to be cleared.
| Constant | Value |
|---|---|
Qt3DRender::QMemoryBarrier::None | 0 |
Qt3DRender::QMemoryBarrier::ElementArray | (1 << 1) |
Qt3DRender::QMemoryBarrier::Uniform | (1 << 2) |
Qt3DRender::QMemoryBarrier::TextureFetch | (1 << 3) |
Qt3DRender::QMemoryBarrier::ShaderImageAccess | (1 << 4) |
Qt3DRender::QMemoryBarrier::Command | (1 << 5) |
Qt3DRender::QMemoryBarrier::PixelBuffer | (1 << 6) |
Qt3DRender::QMemoryBarrier::TextureUpdate | (1 << 7) |
Qt3DRender::QMemoryBarrier::BufferUpdate | (1 << 8) |
Qt3DRender::QMemoryBarrier::FrameBuffer | (1 << 9) |
Qt3DRender::QMemoryBarrier::TransformFeedback | (1 << 10) |
Qt3DRender::QMemoryBarrier::AtomicCounter | (1 << 11) |
Qt3DRender::QMemoryBarrier::ShaderStorage | (1 << 12) |
Qt3DRender::QMemoryBarrier::QueryBuffer | (1 << 13) |
Qt3DRender::QMemoryBarrier::VertexAttributeArray | (1 << 0) |
Qt3DRender::QMemoryBarrier::All | 0xFFFFFFFF |
The Operations type is a typedef for QFlags<Operation>. It stores an OR combination of Operation values.