The Linux driver implementer’s API guide¶
The kernel offers a wide variety of interfaces to support the development of device drivers. This document is an only somewhat organized collection of some of those interfaces — it will hopefully get better over time! The available subsections can be seen below.
Table of contents
- Driver Model
- Driver Basics
- Device drivers infrastructure
- ioctl based interfaces
- Early Userspace
- CPU and Device Power Management
- The Common Clk Framework
- Bus-Independent Device Accesses
- Buffer Sharing and Synchronization
- Device links
- Component Helper for Aggregate Drivers
- Message-based devices
- InfiniBand and Remote DMA (RDMA) Interfaces
- Managing Ownership of the Framebuffer Aperture
- Frame Buffer Library
- Voltage and current regulator API
- Reset controller API
- Industrial I/O
- Input Subsystem
- Linux USB API
- The Linux-USB Host Side API
- USB Gadget API for Linux
- USB Anchors
- USB bulk streams
- USB core callbacks
- USB DMA
- USB Request Block (URB)
- Power Management for USB
- USB hotplugging
- USB device persistence during system suspend
- USB Error codes
- Writing USB Device Drivers
- Synopsys DesignWare Core SuperSpeed USB 3.0 Controller
- Writing a MUSB Glue Layer
- USB Type-C connector class
- API for USB Type-C Alternate Mode drivers
- USB3 debug port
- Firewire (IEEE 1394) driver Interface Guide
- The Linux PCI driver implementer’s API guide
- Compute Express Link
- Serial Peripheral Interface (SPI)
- I2C and SMBus Subsystem
- IPMB Driver for a Satellite MC
- The Linux IPMI Driver
- I3C subsystem
- Generic System Interconnect Subsystem
- Device Frequency Scaling
- High Speed Synchronous Serial Interface (HSI)
- Error Detection And Correction (EDAC) Devices
- SCSI Interfaces Guide
- libATA Developer’s Guide
- target and iSCSI Interfaces Guide
- The Common Mailbox Framework
- MTD NAND Driver Programming Interface
- Parallel Port Devices
- 16x50 UART Driver
- Pulse-Width Modulation (PWM)
- Intel(R) Management Engine Interface (Intel(R) MEI)
- Memory Technology Device (MTD)
- MMC/SD/SDIO card support
- Non-Volatile Memory Device (NVDIMM)
- W1: Dallas’ 1-wire bus
- The Linux RapidIO Subsystem
- Writing s390 channel device drivers
- VME Device Drivers
- Linux 802.11 Driver Developer’s Guide
- The Userspace I/O HOWTO
- Linux Firmware API
- PINCTRL (PIN CONTROL) subsystem
- Top-level interface
- Pin groups
- Pin configuration
- Interaction with the GPIO subsystem
- PINMUX interfaces
- What is pinmuxing?
- Pinmux conventions
- Pinmux drivers
- Pin control interaction with the GPIO subsystem
- GPIO mode pitfalls
- Board/machine configuration
- Complex mappings
- Pin control requests from drivers
- Drivers needing both pin control and GPIOs
- System pin control hogging
- Runtime pinmuxing
- Debugfs files
- General Purpose Input/Output (GPIO)
- Introduction
- Using GPIO Lines in Linux
- GPIO Driver Interface
- GPIO Descriptor Consumer Interface
- GPIO Mappings
- Subsystem drivers using GPIO
- Legacy GPIO Interfaces
- A driver for a selfmade cheap BT8xx based PCI GPIO-card (bt8xxgpio)
- Core
- ACPI support
- Device tree support
- Device-managed API
- sysfs helpers
- RAID
- Media subsystem kernel internal API
- Miscellaneous Devices
- Near Field Communication
- DMAEngine documentation
- Linux kernel SLIMbus support
- SoundWire Documentation
- Thermal
- CPU cooling APIs How To
- CPU Idle Cooling
- Generic Thermal Sysfs driver How To
- Power allocator governor tunables
- Kernel driver exynos_tmu
- Exynos Emulation Mode
- Intel Powerclamp Driver
- Kernel driver nouveau
- Kernel driver: x86_pkg_temp_thermal
- Intel(R) Dynamic Platform and Thermal Framework Sysfs Interface
- FPGA Subsystem
- ACPI Support
- Auxiliary Bus
- Kernel driver lp855x
- Kernel Connector
- Console Drivers
- Dell Systems Management Base Driver
- EISA bus support
- ISA Drivers
- ISA Plug & Play support by Jaroslav Kysela <perex@suse.cz>
- The io_mapping functions
- Ordering I/O writes to memory-mapped addresses
- Generic Counter Interface
- Memory Controller drivers
- MEN Chameleon Bus
- NTB Drivers
- NVMEM Subsystem
- PARPORT interface documentation
- PPS - Pulse Per Second
- PTP hardware clock infrastructure for Linux
- Generic PHY Framework
- Pulse Width Modulation (PWM) interface
- PLDM Firmware Flash Update Library
- Overview of the
pldmfw
library - rfkill - RF kill switch support
- Support for Serial devices
- SM501 Driver
- Surface System Aggregator Module (SSAM)
- Linux Switchtec Support
- Sync File API Guide
- TTY
- VFIO Mediated devices
- VFIO - “Virtual Function I/O”
- Acceptance criteria for vfio-pci device specific driver variants
- Xilinx FPGA
- Xillybus driver for generic FPGA interface
- Writing Device Drivers for Zorro Devices
- The Linux Hardware Timestamping Engine (HTE)