2.3. Debian GNU/Linux¶
This section describes how to install Groonga related deb packages on
Debian GNU/Linux. You can install them by apt.
We distribute both 32-bit and 64-bit packages but we strongly recommend a 64-bit package for server. You should use a 32-bit package just only for tests or development. You will encounter an out of memory error with a 32-bit package even if you just process medium size data.
2.3.1. bullseye¶
New in version 11.0.2.
Install groonga-apt-source:
% sudo apt update
% sudo apt install -y -V wget
% wget https://packages.groonga.org/debian/groonga-apt-source-latest-bullseye.deb
% sudo apt install -y -V ./groonga-apt-source-latest-bullseye.deb
% sudo apt update
Install:
% sudo apt install -y -V groonga
Note
groonga package is the minimum set of fulltext search engine.
If you want to use Groonga for server use, you can install
additional preconfigured packages.
There are two packages for server use.
groonga-httpd (nginx and HTTP protocol based server package)
groonga-server-gqtp (GQTP protocol based server package)
See Server section about details.
If you want to use MeCab as a tokenizer, install groonga-tokenizer-mecab package.
Install groonga-tokenizer-mecab package:
% sudo apt install -y -V groonga-tokenizer-mecab
If you want to use TokenFilterStem as a token filter, install
groonga-token-filter-stem package.
Install groonga-token-filter-stem package:
% sudo apt install -y -V groonga-token-filter-stem
There is a package that provides Munin plugins. If you want to monitor Groonga status by Munin, install groonga-munin-plugins package.
Install groonga-munin-plugins package:
% sudo apt install -y -V groonga-munin-plugins
There is a package that provides MySQL compatible normalizer as a Groonga plugin. If you want to use that one, install groonga-normalizer-mysql package.
Install groonga-normalizer-mysql package:
% sudo apt install -y -V groonga-normalizer-mysql
Note
If you use systemd as init, current version of Groonga does not support to register start-up service automatically during installation. If you want to register groonga-httpd/groonga-server-gqtp as a automatic start-up service, please execute the following commands:
For groonga-httpd:
% sudo systemctl enable groonga-httpd
For groonga-server-gqtp:
% sudo systemctl enable groonga-server-gqtp
2.3.2. Build from source¶
Install required packages to build Groonga for Debian bullseye:
% sudo apt install -y -V build-essential pkg-config zlib1g-dev libmsgpack-dev libzmq3-dev libevent-dev libmecab-dev liblz4-dev
Download source:
% wget https://packages.groonga.org/source/groonga/groonga-13.0.0.tar.gz
% tar xvzf groonga-13.0.0.tar.gz
% cd groonga-13.0.0
Configure (see configure about configure options):
% ./configure
Build:
% make -j$(nproc)
Install:
% sudo make install