pvsadsyn — Resynthesize using a fast oscillator-bank.
inoscs -- The number of analysis bins to synthesise. Cannot be larger than the size of fsrc (see pvsinfo), e.g. as created by pvsanal. Processing time is directly proportional to inoscs.
ibinoffset (optional, default=0) -- The first (lowest) bin to resynthesise, counting from 0 (default = 0).
ibinincr (optional) -- Starting from bin ibinoffset, resynthesize bins ibinincr apart.
iinit (optional) -- Skip reinitialization. This is not currently implemented for any of these opcodes, and it remains to be seen if it is even practical.
kfmod -- Scale all frequencies by factor kfmod. 1.0 = no change, 2 = up one octave.
pvsadsyn is experimental, and implements the oscillator bank using a fast direct calculation method, rather than a lookup table. This takes advantage of the fact, empirically arrived at, that for the analysis rates generally used, (and presuming analysis using pvsanal, where frequencies in a bin change only slightly between frames) it is not necessary to interpolate frequencies between frames, only amplitudes. Accurate resynthesis is often contingent on the use of pvsanal with iwinsize = ifftsize*2.
This opcode is the most likely to change, or be much extended, according to feedback and advice from users. It is likely that a full interpolating table-based method will be added, via a further optional iarg. The parameter list to pvsadsyn mimics that for pvadd, but excludes spectral extraction.
Here is an example of the pvsadsyn opcode. It uses the file pvsadsyn.csd.
Example 805. Example of the pvsadsyn opcode.
See the sections Real-time Audio and Command Line Flags for more information on using command line flags.
<CsoundSynthesizer> <CsOptions> ; Select audio/midi flags here according to platform ; Audio out Audio in -odac ;;;RT audio I/O ; For Non-realtime ouput leave only the line below: ; -o pvsadsyn.wav -W ;;; for file output any platform </CsOptions> <CsInstruments> sr = 44100 ksmps = 16 nchnls = 2 0dbfs = 1 ;; example written by joachim heintz 2009 ; (additions by Menno Knevel 2021) opcode FileToPvsBuf, iik, Siiii ;;writes an audio file at the first k-cycle to a fft-buffer (via pvsbuffer) Sfile, ifftsize, ioverlap, iwinsize, iwinshape xin ktimek timeinstk if ktimek == 1 then ilen filelen Sfile kcycles = ilen * kr; number of k-cycles to write the fft-buffer kcount init 0 loop: ain soundin Sfile fftin pvsanal ain, ifftsize, ioverlap, iwinsize, iwinshape ibuf, ktim pvsbuffer fftin, ilen + (ifftsize / sr) loop_lt kcount, 1, kcycles, loop xout ibuf, ilen, ktim endif endop instr 1 istretch = p4; time stretching factor ifftsize = 1024 ioverlap = ifftsize / 4 iwinsize = ifftsize iwinshape = 1; von-Hann window ibuffer, ilen, k0 FileToPvsBuf "fox.wav", ifftsize, ioverlap, iwinsize, iwinshape p3 = istretch * ilen; set p3 to the correct value prints "--**new duration of note = %f seconds**--\n", p3 ktmpnt linseg 0, p3, ilen; time pointer fread pvsbufread ktmpnt, ibuffer; read the buffer aout pvsadsyn fread, 50, 1, p5; resynthesis of 50 bins, with offset p5 aout *= .7 ; scale amplitude outs aout, aout endin </CsInstruments> <CsScore> ; stretch offset i 1 0 1 10 0 i 1 28 1 5 30 e </CsScore> </CsoundSynthesizer>