Description

lposcilsa2 reads stereo sampled sound from a table with looping and high precision.

Syntax

ar1, ar2 lposcilsa2 aamp, kfreqratio, kloop, kend, ift [,iphs] 

Initialization

ift -- function table number

iphs -- initial phase (in samples)

Performance

ar1, ar2 -- output signal

aamp -- amplitude

kfreqratio -- multiply factor of table frequency (for example: 1 = original frequency, 2 = an octave up). Only integers are allowed

kloop -- start loop point (in samples)

kend -- end loop point (in samples)

lposcilsa2 is the same as lposcilsa, but no interpolation is implemented and only works with integer kfreqratio values. Much faster than lposcilsa, it is mainly intended to be used with kfreqratio = 1, being in this case a fast substitute of soundin, since the soundfile must be entirely loaded in memory.

Examples

Here is an example of the lposcilsa2 opcode. It uses the file lposcilsa2.csd.

<CsoundSynthesizer>
<CsOptions>
; Select audio/midi flags here according to platform
-odac      ;;;realtime audio out
;-iadc    ;;;uncomment -iadc if realtime audio input is needed too
; For Non-realtime ouput leave only the line below:
; -o lposcilsa2.wav -W ;;; for file output any platform
</CsOptions>
<CsInstruments>

; additions by Menno Knevel 2022

sr = 44100
ksmps = 32
nchnls = 2
0dbfs  = 1

instr 1

kcps  = 1					;only integers are allowed
kloop = 0					;loop start time in samples
kend  = 45000					;loop end time in samples

aenv expsega 0.01, 0.2*p3, .9, 0.1*p3, 0.2, 0.5*p3, 0.7	;envelope
aL, aR lposcilsa2 aenv, kcps, kloop, kend, 1	;use it for amplitude
     outs aL, aR

endin
</CsInstruments>
<CsScore>
; Its table size is deferred,
; and format taken from the soundfile header.
f 1 0 0 1 "drumsSlp.wav" 0 0 0

; This will loop the drum pattern several times.
i 1 0 10.4
i 1 11 5

e
</CsScore>
</CsoundSynthesizer>

See Also

lposcil, lposcila, lposcilsa

Credits

Author: Gabriel Maldonado

New in version 5.06