sam_start - Start health checking
#include <corosync/sam.h>
cs_error_t sam_start (void);
The sam_start function is used to start health checking of application. After calling this function, the active process needs to send healthchecks within the registered time interval by calling sam_hc_send(3). If event driven healthchecking is configured by calling sam_register(3), an internal thread will be created and send health check confirmations four times per time_interval.
Application must be registered by calling sam_register(3) before this function can be called.
An application can always stop health checking by calling the sam_stop(3) function.
If SAM is initialized with quorum policy SAM_RECOVERY_POLICY_QUIT or SAM_RECOVERY_POLICY_RESTART sam_start will block until corosync becomes quorate.
This call return CS_OK value if successful, otherwise and error is returned. If SAM is initialized with quorum policy, returned error can also be quorum error.
CS_ERR_BAD_HANDLE
component was not registered by calling sam_register(3) function.
sam_hc_send(3), sam_stop(3), sam_register(3), sam_hc_callback_register(3)
CS_ERR_TRY_AGAIN Resource temporarily unavailable
CS_ERR_INVALID_PARAM Invalid argument
CS_ERR_ACCESS Permission denied
CS_ERR_LIBRARY The connection failed
CS_ERR_INTERRUPT System call interrupted by a signal
CS_ERR_NOT_SUPPORTED The requested protocol/functionality not supported
CS_ERR_MESSAGE_ERROR Incorrect auth message received
CS_ERR_NO_MEMORY Not enough memory to complete the requested task