QPasswordDigestor Namespace

Function Documentation

QByteArray QPasswordDigestor::deriveKeyPbkdf1(QCryptographicHash::Algorithm algorithm, const QByteArray &data, const QByteArray &salt, int iterations, quint64 dkLen)

Returns a hash computed using the PBKDF1-algorithm as defined in RFC 8018.

The function takes the data and salt, and then hashes it repeatedly for iterations iterations using the specified hash algorithm. If the resulting hash is longer than dkLen then it is truncated before it is returned.

This function only supports SHA-1 and MD5! The max output size is 160 bits (20 bytes) when using SHA-1, or 128 bits (16 bytes) when using MD5. Specifying a value for dkLen which is greater than this results in a warning and an empty QByteArray is returned. To programmatically check this limit you can use QCryptographicHash::hashLength. Furthermore: the salt must always be 8 bytes long!

This function was introduced in Qt 5.12.

See also deriveKeyPbkdf2, QCryptographicHash, and QCryptographicHash::hashLength.

QByteArray QPasswordDigestor::deriveKeyPbkdf2(QCryptographicHash::Algorithm algorithm, const QByteArray &data, const QByteArray &salt, int iterations, quint64 dkLen)

Derive a key using the PBKDF2-algorithm as defined in RFC 8018.

This function takes the data and salt, and then applies HMAC-X, where the X is algorithm, repeatedly. It internally concatenates intermediate results to the final output until at least dkLen amount of bytes have been computed and it will execute HMAC-X iterations times each time a concatenation is required. The total number of times it will execute HMAC-X depends on iterations, dkLen and algorithm and can be calculated as iterations * ceil(dkLen / QCryptographicHash::hashLength(algorithm)).

This function was introduced in Qt 5.12.

See also deriveKeyPbkdf1, QMessageAuthenticationCode, and QCryptographicHash.