Install and configure the backup service

Install and configure the backup service

Optionally, install and configure the backup service. For simplicity, this configuration uses the Block Storage node and the Object Storage (swift) driver, thus depending on the Object Storage service.

Note

You must install and configure a storage node prior to installing and configuring the backup service.

Install and configure components

Note

Perform these steps on the Block Storage node.

  1. Install the packages:

    # yum install openstack-cinder
    
  2. Edit the /etc/cinder/cinder.conf file and complete the following actions:

    1. In the [DEFAULT] section, configure backup options:

      [DEFAULT]
      # ...
      backup_driver = cinder.backup.drivers.swift.SwiftBackupDriver
      backup_swift_url = SWIFT_URL
      

      Replace SWIFT_URL with the URL of the Object Storage service. The URL can be found by showing the object-store API endpoints:

      $ openstack catalog show object-store
      

Finalize installation

Start the Block Storage backup service and configure it to start when the system boots:

# systemctl enable openstack-cinder-backup.service
# systemctl start openstack-cinder-backup.service
Creative Commons Attribution 3.0 License

Except where otherwise noted, this document is licensed under Creative Commons Attribution 3.0 License. See all OpenStack Legal Documents.