#!/bin/bash
# rnd.sh: Outputs a 10-digit random number

# Script by Stephane Chazelas.

head -c4 /dev/urandom | od -N4 -tu4 | sed -ne '1s/.* //p'


# =================================================================== #

# Analysis
# --------

# head:
# -c4 option takes first 4 bytes.

# od:
# -N4 option limits output to 4 bytes.
# -tu4 option selects unsigned decimal format for output.

# sed: 
# -n option, in combination with "p" flag to the "s" command,
# outputs only matched lines.



# The author of this script explains the action of 'sed', as follows.

# head -c4 /dev/urandom | od -N4 -tu4 | sed -ne '1s/.* //p'
# ----------------------------------> |

# Assume output up to "sed" --------> |
# is 0000000 1198195154\n

#  sed begins reading characters: 0000000 1198195154\n.
#  Here it finds a newline character,
#+ so it is ready to process the first line (0000000 1198195154).
#  It looks at its <range><action>s. The first and only one is

#   range     action
#   1         s/.* //p

#  The line number is in the range, so it executes the action:
#+ tries to substitute the longest string ending with a space in the line
#  ("0000000 ") with nothing (//), and if it succeeds, prints the result
#  ("p" is a flag to the "s" command here, this is different
#+ from the "p" command).

#  sed is now ready to continue reading its input. (Note that before
#+ continuing, if -n option had not been passed, sed would have printed
#+ the line once again).

#  Now, sed reads the remainder of the characters, and finds the
#+ end of the file.
#  It is now ready to process its 2nd line (which is also numbered '$' as
#+ it's the last one).
#  It sees it is not matched by any <range>, so its job is done.

#  In few word this sed commmand means:
#  "On the first line only, remove any character up to the right-most space,
#+ then print it."

# A better way to do this would have been:
#           sed -e 's/.* //;q'

# Here, two <range><action>s (could have been written
#           sed -e 's/.* //' -e q):

#   range                    action
#   nothing (matches line)   s/.* //
#   nothing (matches line)   q (quit)

#  Here, sed only reads its first line of input.
#  It performs both actions, and prints the line (substituted) before
#+ quitting (because of the "q" action) since the "-n" option is not passed.

# =================================================================== #

# An even simpler altenative to the above one-line script would be:
#           head -c4 /dev/urandom| od -An -tu4

exit