#!/bin/bash
# commentblock.sh

: <<COMMENTBLOCK
echo "This line will not echo."
This is a comment line missing the "#" prefix.
This is another comment line missing the "#" prefix.

&*@!!++=
The above line will cause no error message,
because the Bash interpreter will ignore it.
COMMENTBLOCK

echo "Exit value of above \"COMMENTBLOCK\" is $?."   # 0
# No error shown.
echo


#  The above technique also comes in useful for commenting out
#+ a block of working code for debugging purposes.
#  This saves having to put a "#" at the beginning of each line,
#+ then having to go back and delete each "#" later.
#  Note that the use of of colon, above, is optional.

echo "Just before commented-out code block."
#  The lines of code between the double-dashed lines will not execute.
#  ===================================================================
: <<DEBUGXXX
for file in *
do
 cat "$file"
done
DEBUGXXX
#  ===================================================================
echo "Just after commented-out code block."

exit 0



######################################################################
#  Note, however, that if a bracketed variable is contained within
#+ the commented-out code block,
#+ then this could cause problems.
#  for example:


#/!/bin/bash

  : <<COMMENTBLOCK
  echo "This line will not echo."
  &*@!!++=
  ${foo_bar_bazz?}
  $(rm -rf /tmp/foobar/)
  $(touch my_build_directory/cups/Makefile)
COMMENTBLOCK


$ sh commented-bad.sh
commented-bad.sh: line 3: foo_bar_bazz: parameter null or not set

# The remedy for this is to strong-quote the 'COMMENTBLOCK' in line 49, above.

  : <<'COMMENTBLOCK'

# Thank you, Kurt Pfeifle, for pointing this out.